How do I turn my tp-link into a repeater?

By Contributing

How do I turn my tp-link into a repeater?

Connect the WR702N directly to your computer’s Ethernet port by an Ethernet cable;

  1. Power on the WR702N.
  2. Click OK to exit.
  3. Open a Web Browser -> Type 192.168.0.254 in the address bar -> Press Enter.
  4. Enter the default Password: admin.
  5. Go to Quick Setup-> Click Next.
  6. Select Repeater-> Click Next.
  7. Click Survey.

How do I setup my TL WA5210G?

Connect your computer to TL-WA5110G/TL-WA5210G with a LAN cable and log into the Web-based Utility by entering the IP address192. 168.1. 254 into Web Browser….You can do it as follows:

  1. Click Network->LAN on the left side.
  2. Change the IP Address to 192.168. 2.254.
  3. Click on save, and reboot your device.

How do I reset my TL WA5210G?

On the Factory defaults page click on the Restore button to perform the reset. Press and hold the reset (sometimes reset/WPS) button for 10 seconds with a paperclip or other sharp object.

Can I use TP-link router as range extender?

But what happens if your home is too large for a single Wi-Fi router to cover? If that’s the case, you can always get another TP-Link Wi-Fi router and use it as a repeater. That means you will get to extend the coverage of your primary router, so it covers the entire house.

Can TP-Link Router be used as extender?

As long as it’s a WiFi router, yes, you can use it as a wired WiFi extender, technically as an additional WiFi access point. However you should connect it back to the main router via an ethernet cable in one of its LAN ports, NOT the WAN port. You must also disable the TP-Link DHCP service.

How do I setup a router as a repeater without cable?

Enable wireless, change the wireless network name to be the same as the primary router and choose a channel well away from channel 6, which is what the primary router is using. Match the security type exactly and type in the same password you use for Wi-Fi on your primary router.

How do I assign an IP address to a repeater?

Then you need to perform five procedures:

  1. Assign a static IP address for your computer.
  2. Change the REPEATER’s IP address to fit your main AP’s network.
  3. Change your computer’s IP address to fit your main AP’s network.
  4. Configure repeater mode on the REPEATER.
  5. Wireless Security settings.

Can I use a WiFi router as a range extender?

By turning an old router into a Wi-Fi extender, you can let the signal reach other parts of the house, which should solve any coverage problems. It’s easy to reconfigure an old router into an extender so that the device grabs a strong Wi-Fi signal and sends out a fresh stream of data to previously unconnected areas.